Product Description

Product Name	CMO-S3008
Material	Environmentally friendly materials
Function	Fun personal water propeller,perfect for Swimming,snorkeling and diving Adjustable buoyancy for use on the surface or Deeper down
Package	Carton

Product performance description

Depth range:25 meters Max speed:5km/h Power:500W Run time:30-50 minutes on one full charge Charging time:5-6 hours Battery:6Ah,24V lead-acid battery Dimensions:60*36*31cm Weight:8.2kg(battery included) Minimum recommended age:16 years Package contains:Sea Scooter with Battery Sealing O-ring,Grease Lubrication,Instruction

Camoro water scoote scuba diving equipment 500W electric scooters other water play swimming equipment

The battery status indicator only functions when the propeller is turning. Using the water scooter for diving adjusting the
buoyancy Your water scooter can be used for diving up to 25m but will need to be adjusted for neutral buoyancy. The water scooter
must never be adjusted for negative buoyancy to avoid it sinking if accidentally released.

When you use the WATER SCOOTER for the first time, the battery needs to be charged.(read more on this on the following pages) When
the WATER SCOOTER is fully charged and assembled ,it is ready to use. The start button is located on the right side of the handle.
Press down the start button,and then press the accelerator button located on the left side to make the WATER SCOOTER move
forwarder under the water.

1. Charge the battery and install just before use. 2. Make sure that Vent Plug is closed. 3. Place the water scooter into the water so the Handle, Outer Nose Cone and Nozzle fill with water. 4. When ready to set off, switch the Master Switch to the On position 5.Pull and hold both Triggers to start the Propeller. (There is a short delay before the Propeller begins to rotate). 6.To stop the Propeller, simply release the Trigger. 7. Always turn the Master Switch off when out of the water. 8. Proper posture when using the water SCOOTER is important to achieve the maximum speed - s for the correct position of the water scooter when using it.

Product Usage

• Always charge the battery to the fullest before using the water scooter •The battery can be charged directly in the scooter,make
sure to turn OFF the o\power switch. •The Battery Housing should always be ventilated during charging to allow potentially
explosive gases to dissipate.Before removing/attaching any battery cables always allow two minutes for any gases to dissipate. •
Always remove the battery from the battery housing

before charging. • Always connect charger jack to the battery first and then plug charger into the mains. •NEVER place the battery in a sealed container when charging. •Never charge battery near water. •If in doubt of the state of the battery,recharge it until the indicator on the battery charger flashes indicating a full charge. •ALWAYS charge battery in a well-ventilated place,not in direct sunlight,and keep it out of reach for children. ALWAYS ensure the unit is dried thoroughly before opening the Nose Cone for charging or changing the battery.